Hello,
I got current SD version - 11.31.
I found that when I start it - the settings of
PTTTAIL go back to very looooooong.
When I call PTTTAIL command ( or PTTLEAD ) - it shows
the time in miliseconds that I did enter before ..
So - accepting this value will correct the problem,
but only for duration of the session.
Again - after closing and starting the program again
- it will have very long PTTTAIL time.
(perhaps it goes to the max settings ??)
I did not have this problem in olders SD versions.
Any advice ?? - thank's de Andrew VK2AR
A. Borynski
arcfn@yahoo.com
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|