RTTY
[Top] [All Lists]

Re: [RTTY] Flex 6000 users

To: Trevor Dunne <trevor_dunne@yahoo.com>
Subject: Re: [RTTY] Flex 6000 users
From: Neal Campbell <nealk3nc@gmail.com>
Date: Tue, 23 Jan 2018 23:02:09 -0500
List-post: <mailto:rtty@contesting.com>
I am also!


Neal Campbell

Abroham Neal Software
www.abrohamnealsoftware.com



See components used in our computers at:
https://www.amazon.com/shop/abrohamnealllc




On Tue, Jan 23, 2018 at 10:43 PM, Trevor Dunne via RTTY <rtty@contesting.com
> wrote:

> I am in RTTY,
>
>
> Thanks
> Trevor
> EI2GLB
>
> --------------------------------------------
> On Wed, 24/1/18, Bill Turner <dezrat@outlook.com> wrote:
>
>  Subject: Re: [RTTY] Flex 6000 users
>  To: "RTTY Reflector" <rtty@contesting.com>
>  Date: Wednesday, 24 January, 2018, 2:29
>
>  I have a Flex 6300 and it does go
>  all the way up to 10.149.9 and keys
>  normally.  Are you in RTTY mode or something
>  else?
>
>  73, Bill W6WRT
>
>
>  ------------
>  ORIGINAL MESSAGE ------------(may be snipped)
>
>  On Wed, 24 Jan 2018 01:26:01 +0000 (UTC), you
>  wrote:
>
>  >Hi All
>  >
>  >I wonder is there
>  anyone here using any of the 6000 series Flex radios.
>  >
>  >I have an issue on 30m
>  using smart sdr in RTTY mode I can not tx above 10.145.0 no
>  matter how I key the radio,
>  >
>  >My limited understanding is that in RTTY
>  mode my dial frequency should be within band all the way up
>  to 10.149.8 ??
>  >
>  >Is
>  that correct can anyone here using a flex test it and see if
>  you can tx that high.
>  >
>  >
>  >Thanks
>  >Trevor
>  >EI2GLB
>  _______________________________________________
>  RTTY mailing list
>  RTTY@contesting.com
>  http://lists.contesting.com/mailman/listinfo/rtty
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>