RTTY
[Top] [All Lists]

Re: [RTTY] Q Rate Killers

To: rtty@contesting.com
Subject: Re: [RTTY] Q Rate Killers
From: Steve Bookout <steve@nr4m.com>
Date: Mon, 26 Sep 2016 22:22:54 -0400
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
Art,

It would depend upon how well your station plays (loud).

If condx are good, and you have a good path to where your target DX is, then maybe just 'his call', 'state' and 'zone', without your call would be enough in the exchange. If condx get noisy, QRM or QRN, then you may need his call and your call with a couple of 'state' and 'zone' exchanges.

You need to do as much as you need to, but only that much, in order to cleanly make the QSO, with few repeats.

100 watts and a dipole will most likely require a different exchange than 1500 watts and stacked yagis.

73 de Steve, NR4M


On 9/26/2016 10:02:PM, Art (K5FNQ) wrote:
then what is the recommended minimum and maximum to send?

N1MM default has "his call, sec, state, sec, state, mycall"

At times with a strong station I would hit escape before "my call" was sent. I had no problem with that.

Cutting to "sec state sec state" scares me that the other station might not have my call or I might have busted his?

Art K5FNQ



On 9/26/2016 20:56, Steve Bookout wrote:

If you can be loud, then you can send less stuff. Unfortunately, not everyone can be loud all the time.

I start with one of each exchange element and if it's noisy and I'm getting a bunch or requests for repeats, then I'll add additional exchange info.

Steve

On 9/26/2016 9:16:PM, Jeff AC0C wrote:
Tom,

The exchange content for peak efficiency is just on the border where you are infrequently asked for a fill. If you almost never get a request, then I would say your content is too redundant. Keeping it simple, on the next contest drop your exchange by one of each element and see how it goes. In any event, do drop the "UR" out of it in all cases.

Have fun!

73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie

-----Original Message----- From: Tom Magarelli
Sent: Monday, September 26, 2016 7:37 PM
To: RTTY@contesting.com
Subject: Re: [RTTY] Q Rate Killers


I'm not sure if I'm one of the guilty parties

My exchange was   K4SBZ  UR 599 NJ NJ NJ 05 05 05

My thought was to send my state and zone 3 times, hopefully not needing a repeat. That seemed to work I only had 1 station ask me for a repeat of my
State. My thinking was not having a lot of repeats, I could make more
contacts and move along quicker.

Please tell me if my thinking is wrong. I'm not in the big league either,
just trying to have some fun.


-----Original Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of Stanley
Zawrotny
Sent: Monday, September 26, 2016 7:41 PM
To: RTTY@contesting.com
Subject: [RTTY] Q Rate Killers

A while back, there was a discussion about how extra spaces and characters
slow down an exchange. Those a nothing compared to the many ops that I
worked in the CQ WW DX RTTY Contest last weekend that took 15-20 seconds or longer to reply. I'm not in the big leagues and worry about milliseconds, but when it takes almost a minute to complete a contact, that gets to me.

Stan, K4SBZ

"Real radio bounces off the sky."
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty


_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty



_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>