See the main page at http://www.ewarg.org for Chen's Regen stuff on the
ST-8000.
Also the front panel switch under Regen would be set B/B for
Baudot/Baudot. Make sure the Input Mark/Space/Baud equals the output.
The switch marked input/output
shows you what they are.
Good luck.
On 10/26/2014 8:08 AM, Tom Guntzel wrote:
I have just acquired a st8000 and want to use the regen feature. It is my
understanding that the st 8000 will output a clean audio signal that can then
be feed into a sound card program or other hardware that takes an audio input.
I can't tell from the manual where to get this filtered output.
Can anyone help, may have to adjust a couple of dip switches as well.
Help appreciated
Tnx
Tom G
K0TLG
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|