Using lower tone freqs like Bill suggests is one answer, but I usually just
turn down the volume to just the threshold where I can hear to tune. That
may sound flip but I used to keep the volume a lot higher than I needed to.
Once I started experimenting with how low I could go with it I found I
could use a lot lower volume than I thought after some practice. You may
also find after lowering the tone freqs lets you choose a lower volume than
at a higher freq.
One caveat is that the reason 2125/2295 became a "standard" is that any
mixing artifacts are outside the passband of a typical SSB transmitter.
When you go lower those artifacts start to come into the passband.
Something to check on.
Have fun! jeff wk6i
On Fri, Jul 25, 2014 at 10:11 AM, Bill Turner <dezrat@outlook.com> wrote:
> ORIGINAL MESSAGE: (may be snipped)
>
> > However, I noticed an annoying disadvantage when I did this. With the
> > narrow filter engaged, the background noise becomes much higher in pitch,
> > to the point that I find it quite uncomfortable to listen to.
>
> REPLY:
>
> Perfectly normal. The default tones for RTTY in most transceivers and
> software are 2125 and 2295 Hz. When you narrow down the receiver's filters,
> the white noise falls into that range and that's what you are hearing -
> high pitched white noise.
>
> One alternative is to use lower frequencies if your transceiver and RTTY
> software support them. Many hams use tones in the range of just above 1 kHz
> which may be easier to listen to over a long period of time.
>
> Consult your owner's manual to see if it possible with your present rig.
>
> 73, Bill W6WRT
>
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
--
Jeff Stai ~ wk6i.jeff@gmail.com
Twisted Oak Winery ~ http://www.twistedoak.com/
Facebook ~ http://www.facebook.com/twistedoak
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|