Joe is right.
Pin 9 mutes the front panel mic hi input.
Feed the audio in pin 11, put the radio in LSB, ground pin 9 and you
ought to get power out.
Why switch to AFSK if FSK was working?
GL de W1EL
On 1/29/2014 8:15 PM, Lee wrote:
Actually, this wouldn't be specific to fldigi since it's a general issue for
AFSK.
Anyway, I was using pin 9 with FSK and N1MM and that was working. For AFSK, it
is my understanding that pin 9 will mute the microphone input on pin 11.
According to the TS2000 manual, I need to key the radio with pin 13 so that
pin 11 isn't muted on key down.
I've tried both pin 9 and pin 13 with the same result (no AFSK transmitted).
Joe Subich, W4TV <lists@subich.com> wrote ..
This should really be asked on the fldigi support forum ...
TS-2000 requires PTT on pin 9 (PKS) when applying audio on pin 11 (PKD).
See the description of those pins on page 94 of the TS-2000 Instruction
Manual.
73,
... Joe, W4TV
On 1/28/2014 9:57 PM, Lee wrote:
I believe that I have my PC-to-radio interface cable set up right but I
can't
seem to transmit any audio. The radio is keyed but no transmit audio. I
have
audio to ACC2-11 and my keying is on ACC2-13. I don't see any radio menu
options that would cause an issue. Also, with the microphone attached, I
can
transmit voice when the PC keys the radio so the microphone audio from
ACC2
shouldn't be muted. Receive is working properly though. What am I missing?
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
--
Eric Lowell
48 Loon Road
Wesley, ME 04686
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|