... and in UPPER SSB...
Remember that the 60 m band channels are UPPER SSB, so
in AFSK, use upper SSB. If you use MMTTY than you also select "rev".
Note that the MMTTY "Mark" nomenclature is incorrect for upper SSB.
You should set your radio dial to the upper SSB dial frequency, and
select a "mark" frequency of 1415 Hz, in "rev" that is actually the
"Space" frequency, so you will end up with the needed 1415/1585 Hz
tone pair.
You will be fully compatible with standard RTTY users, you can even use
the same parameters on any other ham band where RTTY is used.
Please let me know if you need more detailed info, especially about using
MMTTY.
73
Kai, KE4PT
On 11/25/2013 10:50 AM, iain macdonnell - N6ML wrote:
By "carrier frequency", they mean the suppressed carrier when
operating AFSK in an SSB mode.
73,
~iain / N6ML
On Sun, Nov 24, 2013 at 7:54 PM, Bill Turner<dezrat1242@yahoo.com> wrote:
For some reason that defies explanation, I want to try RTTY on 60 meters. I
am trying to figure out what frequency to set my TX to, based on FCC part
97.303(h), quoted below. Here's the problem:
1. If I set my MARK carrier frequency at 1.5 kHz below the channel center
frequency as stated below, the SPACE frequency will be out of the band, I.e.
170 Hz low.
2. If I set my MARK frequency to center frequency + 1/2 of 170 Hz, that
would center my transmission around the channel center. For example, with
channel 1 which has a center f of 5332.000 I should set MARK to 5332.085and
thus SPACE would be 170 Hz lower, thereby centering me in the channel.
So what do I do? I'm thinking #2 is within the spirit of the rules, but
without a specific mention, I'm not sure. Or is it something else entirely?
Any suggestions?
73, Bill W6WRT
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++
FCC part 97.303(h):
(h) 60 m band: (1) In the 5330.5-5406.4 kHz band (60 m band), amateur
stations may transmit only on the five center frequencies specified in the
table below. In order to meet this requirement, control operators of
stations transmitting phone, data, and RTTY emissions (emission designators
2K80J3E, 2K80J2D, and 60H0J2B, respectively) may set the carrier frequency
1.5 kHz below the center frequency as specified in the table below. For CW
emissions (emission designator 150HA1A), the carrier frequency is set to the
center frequency. Amateur operators shall ensure that their emissions do not
occupy more than 2.8 kHz centered on each of these center frequencies.
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|