Hi Guys,
My 2tone disappears on start-up and I wonder if you have any ideas for me?
Running N1MM Logger, when I start the Digital Interface, both MMTTY and
2Tone start up as expected, but the 2tone Window only shows for about a
second and then quickly moves down and off the screen.
Reading the 2tone instructions shown below, it says this happens because "
it is either behind another window on the display or has been minimised".
It is not behind another Window, but perhaps it's getting automatically
minimised somehow?
If I use the N1MM Logger CONFIG/FIND ALL WINDOWS... then the 2tone Windows
appear... but that's time consuming as you must fool around adjusting all
of the windows, so I'd rather 2tone stay on the screen the first time. I
have also tried saving all window positions using the TOOLS/SAVE WINDOWS
POSITIONS, but the 2tone continues to disappear on start-up..
I have gone into the DI1 2tone Window Setup and clicked the "On Top" box,
is that the same as "Topmost on" as described below?
Thanks!
Dick- K9OM
Display: 2Tone checks on start up that it is within the display area of
your monitor(s), if it is not it will
automatically centre itself on the nearest monitor. If the 2Tone window is
not visible it is because it is either
behind another window on the display or has been minimised. Going to Menu
Setup, Topmost on? Checking this
item will put 2Tone always on top.
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|