The Signalink USB provides its own low noise sound card. Go into the
MMTTY setup options and select the Soundcard tab (far right). Make
certain the correct sound card is selected. If your computer has an
internal soundcard, MMTTY usually defaults to that selection.
73 de Bob - KØRC in MN
------------------------------------------------------------------------
On 5/14/2012 12:00 PM, Dick White wrote:
> A few weeks ago I had a near lightning strike that disabled my YAESU Mark-5
> radio. Had it fixed by Byron Campbell and got it back last Saturday.
> Everything was working before it was damaged. Now I have a RTTY problem.
>
> Equip. = Mark-5 Field, Signalink USB, Win. XP Prof., MMTTY and N1MM program
> with MMTTY engine.
> I am not using any CAT control, no band map or telnet functions. CW works
> ok TX and RX. RTTY MMTTY keys the radio as I see power out and so I must be
> transmitting, but no copy on receive. I am seeing the trash stuff, but no
> print when I find a RTTY signal. There is nothing in the FFT display, no
> twin elliptical and no twin peaks on receive and no waterfall. It does print
> my macros and keys the rig when I send.
>
> I have checked the rig menu and all ok. I have read the Signalink manual and
> did the set up two times. MMTTY is set to the Signalink sound card.
> Something has been changed and I have spent two days looking for the cure. I
> will appreciate any and all suggestions as I don't know where to look next.
>
> Thanks Dick KS0M
>
> Richard C. "Dick" White
> Fulton, Missouri 65251 U.S.A.
> whiter26@sbcglobal.net
>
> Amateur Radio Station: KS0M
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|