You'd think that 1 meg resistor would be standard.
73, Bill W6WRT
>________________________________
> From: Jim W7RY <jimw7ry@gmail.com>
>To: Bill Turner <dezrat1242@yahoo.com>; RTTYReflector <rtty@contesting.com>
>Sent: Friday, March 30, 2012 5:05 PM
>Subject: Re: [RTTY] Followup on ESD from last week
>
>That is Icom's standard response when they don't feel like covering
>something under warrantee. They tried to tell me that on a NEW IC-7200 that
>was dead out of the box and had never been on an antenna.
>
>I appealed, they covered it under warrantee.
>
>If there stuff is so susceptible to ESD , it sounds like a design flaw?
>
>
>73
>Jim W7RY
>
>
>--------------------------------------------------
>From: "Bill Turner" <dezrat1242@yahoo.com>
>Sent: Friday, March 30, 2012 2:10 PM
>To: "RTTYReflector" <rtty@contesting.com>
>Subject: [RTTY] Followup on ESD from last week
>
>> Got the report from the factory on my non working IC-7600. Turns out it
>> was ESD damage. Three diodes and one IC were destroyed on the tuner
>> control board. Not covered by warranty of course, so that learning
>> experience cost me $223.45 plus shipping of $85 each way. Ouch.
>>
>> There never was any lightning, just that kind of precipitation static I've
>> heard hundreds of times before, but will never hear again more than a
>> fraction of a second. :-)
>>
>>
>> Take a lesson, boys and girls.
>>
>> 73, Bill W6WRT
>> _______________________________________________
>> RTTY mailing list
>> RTTY@contesting.com
>> http://lists.contesting.com/mailman/listinfo/rtty
>
>_______________________________________________
>RTTY mailing list
>RTTY@contesting.com
>http://lists.contesting.com/mailman/listinfo/rtty
>
>
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|