RTTY
[Top] [All Lists]

Re: [RTTY] bartg sprint 75 sv1dpi

To: rtty@contesting.com
Subject: Re: [RTTY] bartg sprint 75 sv1dpi
From: Roger Cooke <g3ldi@g3ldi.co.uk>
Reply-to: g3ldi@g3ldi.co.uk
Date: Mon, 19 Sep 2011 13:53:25 +0000
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
It's true what Don says. However, these problems can be overcome to 
some extent
by just tweaking the macros slightly. One good example happened to 
me a few times
in this last contest. I sent my report and then waited for the 
return. All I got was a
very short burst, which was his number sent once. QRM covered it 
each time and I
ended up asking for repeats, once I had to ask four times. Now if he 
had sent his
number four times, I would probably have received it. It's still 
faster than 45 and a lot
slicker so time wasted is minimal. I ended up modifying my macros in 
the middle and
sent my exchange four times. I didn't have any repeat requests after 
that.
   75 is difficult on 80 metres however, different band altogether, 
but still manageable.

Lots of fun though at that speed!

73 de Roger, G3LDI

On 19/09/2011 13:18, Don AA5AU wrote:
> There are two things I don't like about 75 baud RTTY contests.  The 
> transmissions are so short that by the time you get a signal tuned while S&P, 
> the message has ended and you have to wait for another transmission.  And as 
> Kostas noted, it is extremely hard to print weak stations.  Signals that 
> would be difficult to print at 45 baud, are impossible to print at 75.  This 
> was particularly true Sunday when I was on 15 meters.  I could tell there 
> were many of what I believed were European stations calling, but I couldn't 
> print anything.
>   
> 75 baud is good for Sprints and domestic contests, but 45 baud is better for 
> DX contests.
>   
> 73, Don AA5AU
>
> From: Robert Chudek - K0RC<k0rc@citlink.net>
>> To: rtty@contesting.com
>> Sent: Monday, September 19, 2011 12:01 AM
>> Subject: Re: [RTTY] bartg sprint 75 sv1dpi
>>
>> I have programmed two new keys into my contest logger... 45 Baud and 75
>> Baud... I will be able to change speeds at the click of a macro button.
>>
>> The CQWW RTTY rules, Section III, Item 12 states "Only Baudot mode is
>> permitted" but it does not set a specific speed limit.
>>
>> It is easy enough to hear the difference between 45 and 75 Baud to be
>> able to click one or the other buttons!
>>
>> 73 de Bob - KØRC in MN
>> ------------------------------------------------------------------------
>>
>>
>> On 9/18/2011 11:51 PM, Kostas Stamatis wrote:
>>> I was watching football (soccer) also like Don... It was very funny and i
>>> think that now it would be difficult next week with too slow 45 baud!!! It
>>> was easy to go over 130 qsos per hour (even with serial numbers). Real
>>> srint.. I noticed that in 75 baud is more difficult to print low signals. At
>>> least there were 2-3 times i couldn't print guys who i was hearing them.
>>> Sorry. I made 180 qsos. in 5 continents. Oceania is difficult on this time
>>> frame for us. 73 to all and tnx for the qsos...
>>> Kostas SV1DPI
>>>
>>> _______________________________________________
>>> RTTY mailing list
>>> RTTY@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/rtty
>>>
>> _______________________________________________
>> RTTY mailing list
>> RTTY@contesting.com
>> http://lists.contesting.com/mailman/listinfo/rtty
>>
>>
>>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>