RTTY
[Top] [All Lists]

Re: [RTTY] microHAM & Kenwood TS-450s

To: RTTY <rtty@contesting.com>
Subject: Re: [RTTY] microHAM & Kenwood TS-450s
From: John Merrill <johnn1jm@gmail.com>
Date: Sat, 9 Jul 2011 09:13:30 -0700
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
All the Kenwoods that I have run are opposite of the default fsk polarity in
the menu when run with Mmtty, Writelog and N1MM.

John N1JM

On Sat, Jul 9, 2011 at 8:39 AM, Joe Subich, W4TV <lists@subich.com> wrote:

>
>  > Hold down the 'm.in' key while turning on the radio.
>  >
>  > Check menu number 38.  It should be set to 'off' for normal FSK.
>
> If this is true (and I have no reason to doubt Tom), it is another
> case in which a Kenwood manual provides incorrect information about
> the operation of the radio.  The Kenwood manual states that "ON"
> represents a "closed" contact (switch "on") for Mark.
>
>   "When the FSK transmission key is shorted, you can change between
>   space transmission (off) and mark transmission (on)."
>
>     - TS-450S/TS-690S Instruction Manual, pg 53.
>
> Almost every modern FSK interface provides an open collector FSK
> output that is *closed* in Mark (pulled to ground) and *open* in
> Space.  This is the same as the "simple" transistor on the output
> of a serial port or USB to RS-232 converter for those using EXTFSK
> with MMTTY.
>
> 73,
>
>    ... Joe, W4TV
>
>
> On 7/9/2011 11:03 AM, Tom Osborne wrote:
> > Hi David
> >
> > Hold down the 'm.in' key while turning on the radio.
> >
> > Check menu number 38.  It should be set to 'off' for normal FSK.
> >
> > Are you using the ACC 2 jack on the back of the '450 for FSK?  You can't
> do
> > FSK through the mic jack like you can PSK.    73
> >
> > Tom W7WHY
> >
> > Hi  Is anyone using the microKEYER II with a Kenwood rig for RTTY?  I
> picked
> > one up to use with a TS-450s as a dedicated digital mode rig.  I've got
> > everthing working and have made a few PSK contacts but there's something
> > wrong with my RTTY signal.  MMTTY is configured for FSK; the microKEYER
> keys
> > up the rig and the rig is transmitting, but other stations only reply
> QRZ??
> > a couple times then continue their CQ call.  I was doing RTTY
> successfully
> > with AFSK thru a Signalink, how would I know if I was transmitting in
> > REVERSE?
> > Any help or ideas
> >
> >
> >      VE3VID         Located in rural Canada
> >
> >
> > _______________________________________________
> > RTTY mailing list
> > RTTY@contesting.com
> > http://lists.contesting.com/mailman/listinfo/rtty
> >
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>