Hi John. And thank you for the thoughts. First of all, TNC emulation is not
activated. Also, I am not using radio command at this point. In both these
features, there are no ports activated “NONE”....and it makes no difference
which port I tried i.e. com 3, 4, 5, or 6. They are all available and not
“apparently” in use at this time as I have all of these ports dedicated for
Writelog and MMTTY use here as has been the case since I last was in a contest
(last fall, I believe for a short time only). Everything worked just fine,
both the radios and writelog and MMTTY running in the background. Think I did
have to use EXTFSK supplimental program with the MMTTY engine if I remember
correctly. In order to use MMTTY with WRITELOG for some reason. Not sure why
but anyway....
NOW
1. Both of my radios FT2000 and FTdx9000D work just fine without any fiddling
around on COM 3, 4, 5, or 6! That is to say that I can bring up Writelog and
control either radio on any of the com ports just dandy. Further, the same is
true with Ham Radio Deluxe program.
So I just can’t think of what else it could be. I am going to go into MMTTY
and see if somehow I can “turn off” the EXTFSK module (assuming that it may be
on from previous use with Writelog in case that module is interfering with the
operation of the stand alone version of MMTTY I am trying to get to communicate
with any of the above mentioned com ports! But don’t believe I had any problem
using this feature before. But who knows. I am going to check that and if I
don’t get back to you within the next hour you know it doesn’t have anything to
do with the problem.
Boy, this is starting to drive me crazzzzy!
Van, K7VS
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|