In N1MM Logger this is true and is a nice feature, however that doesn't
transfer the info into the proper exchange field.
In that case (for N1MM), you shift-click on the TRE in "TOO TRE TRE" and TRE
is converted to "543" and pasted into the exchange field.
If I remember right, using RTTY by WF1B you could click on the text
characters (without holding the shift key) and it would make the conversion
on the fly. I actually liked this better because you didn't need to move
your hand to the keyboard to engage the shift key. (My left hand is usually
on the VFO knob.)
73 de Bob - KØRC in MN
----- Original Message -----
From: "Bill, W6WRT" <dezrat1242@yahoo.com>
To: <rtty@contesting.com>
Sent: Tuesday, July 07, 2009 12:28 PM
Subject: Re: [RTTY] USOS FIGS
> ORIGINAL MESSAGE:
>
> On Tue, 7 Jul 2009 09:52:12 -0700, "WS7I" <ws7i@ewarg.org> wrote:
>
>>
>>Then we must not be using this forumn to its full extent, as I still
>>haven't seen in this thread the method to use in various versions of
>>contesting logging programs the way to click and make all of these
>>TOO-PQU-PQU into something that the newer folks can utilize.
>
> REPLY:
>
> If you're using N1MM Logger, just hover the mouse over the suspicious
> characters
> and the converted numbers will be displayed at the top, just below the
> title
> bar. Doesn't even need a click.
>
> 73, Bill W6WRT
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|