Kok Chen wrote:
>
>As many of you know, I use waveshaped AFSK for RTTY to tightly control
>the FSK keying sidebands, and the K3 has an AFSK transmit IMD that is
>a little high for my taste. With my K3, I'd measured about -24 dB IMD
>at 70 watts peak power using a two tone signal. With my 1000MP, I get
>about 4 dB cleaner transmit IMD when I operate AFSK.
>
>With the PA turned off, the K3 does manage to achieve a very clean -34
>dB transmit IMD at 10 watts and below (rising again below 500 mW to
>-29 dB IMD by 200 mW). But then, at 5 watts, I get a whopping -40 dB
>IMD with the MP.
>
Do you have comparable measurements of spectrum occupancy when the MP
and K3 are keyed by direct FSK?
--
73 from Ian GM3SEK
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|