HNY Steve
The simple solution is to run a stereo cord from external speaker jack
directly to sound card, bypassing the rigblaster. May have to defeat the
recv wire from RTTY jack.
You do not need a second sound card.
I use the MP with the RASCAL.
Tom KA2D
----- Original Message -----
From: "KT0DX" <kt0dx@earthlink.net>
To: <rtty@contesting.com>
Sent: Saturday, December 29, 2007 9:15 PM
Subject: [RTTY] Receiving RTTY on Sub VFO on FT1000MP?
>I would like to know if there is a way to configure the FT 1000MP (Not a
>
> Mark V) to be able to receive RTTY on the Sub VFO. I would like to use
> the Sub VFO to locate the station the DX is working when the DX station
> is operating split. I have spent some time on the internet looking for
> information but have not come across anything.
>
> My set up here is a FT 1000MP and using a RIGblaster plus for the
> interface to the computer. I usually use MMTTY for the program but I
> also have a HAL DXP38.
>
> Will I need a 2nd sound card to do this?
>
> Please if you have any information on this I sure would appreciate it if
> you could e mail me the information direct at KT0DX@earthlink.net.
>
> Thanks
> Steve (KT0DX)
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|