RTTY
[Top] [All Lists]

Re: [RTTY] N1MM and MMTTY setup

To: "'Tad Danley'" <tdanley@verizon.net>, <rtty@contesting.com>
Subject: Re: [RTTY] N1MM and MMTTY setup
From: "John Klim, N3KHK" <n3khk_john@verizon.net>
Reply-to: n3khk_john@verizon.net
Date: Wed, 02 Jan 2008 22:52:56 -0500
List-post: <mailto:rtty@contesting.com>
Tad,

I am using the same configuration as you are.

A couple of questions:
1.      What version of N1MM are you using?
2.      What Version of Router are you using?
3.      Did you follow the MicroHAM instructions on how to configure N1MM?
4.      Are the cables as follows
                MicroKEYER                      PC
                        IN              <====>  IN
                        OUT             <====>  OUT
                        MIC             <====>  MIC
I will be up for about one hour.

 73 ES CUL
================================================= 
Mr. John R. Klim II
N3KHK
ARRL LM-0008416263, AMSAT  LM-2187,  QRPARCI  #10392,  FISTS  # 5015,  MQFD
#115,  
10-X Life Member  # 68135,  Springbok Chapter  # 1874,  Chesapeake Bay
Chapter  # 549
 
 

-----Original Message-----
From: rtty-bounces@contesting.com [mailto:rtty-bounces@contesting.com] On
Behalf Of Tad Danley
Sent: Wednesday, January 02, 2008 9:48 PM
To: rtty@contesting.com
Subject: [RTTY] N1MM and MMTTY setup

Trying to get N1MM and MMTTY set up for the very first time with my 
ProII.  Been listening to the W1AW RTTY bulletin this evening.  
Everything prints fine on the ProII scope using the built-in RTTY 
decoder, but only garbage prints in MMTTY.  Not sure where to start, 
also using a microKEYER.  Settings in MMTTY are 'default', and the 
signal levels and tuning appear to be spot on. 

Any suggestions on things to check out?  Thanks in advance!

73,

-- 
Tad Danley, K3TD
EM10dq


_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>