Hi Duane,
Yes, the Serial port built into the Navigator is a full service serial port.
I have it assigned as comport 8. Thus any of the programs that will
handle com 8 will run on it. I use it with my pk-232 for packet cluster
and spots as we have only one slow speed dial up phone line here
and xyl doesnt like me tying the line up with Telnet...thus vhf Packet.
The MS Hyperterminal program works well with it also.
The Pactor mode via the TNC sounds interesting. I may resurect
that if it ever decides to rain!
For older programs, you could asssign the Navigator Rs-232 port to
say four etc.
Give it a try and let me know how you made out.
73
de Jack / W7LD / "Lucky Dog"
----- Original Message -----
From: "Duane Budd" <dcbudd@embarqmail.com>
To: <w7ld@theriver.com>
Sent: Thursday, November 22, 2007 3:09 AM
Subject: Navigator / TNC
> Hi Jack!
>
> I am interested in your use of the RS232 port on the
> Navigator.
>
> What software do you use with the PK-232 and Navigator? Do
> you know if it is possible to use the RS232 on the Navigator
> with software other than MixW, such as RCKRTTY, XPWare, and
> so forth? If the RS232 port is treated just like a normal
> RS232, it should be possible.
>
> I have lots of TNC's left over from my PacTor days - an SCS
> PTC-IIe, a PK-900, a PK-232/DSP/Soundcard and a KAM. It
> would be fun to operate a bit of PacTor once again, IF I
> could find any non-box PacTor around! Hi
>
> Thanks for your input to the reflector...
>
> Duane Budd, W5BEN
> dcbudd@embarqmail.com
>
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|