Hey Bill,
Just a note, if the radio is left in autobaud, it wont reset itself if you
load a program with a different baud rate. IE: I had ACLog set to 19.2 and
Writelog set to 9600 and the radio set to autobaud. If I loaded either WL
or ACL first, the other wouldn't work without resetting the radio. I of
course solved it by setting all programs to the same, as well as locking in
the baud rate on the radio. No problems after that.
BTW: I too also set the Hex for the Pro2 which was listed, and used the Pro2
setting in WL.
Charlie
KI5XP
> Date: Sat, 01 Apr 2006 07:42:22 -0800
> From: Bill Turner <dezrat@copper.net>
> Subject: Re: [RTTY] WriteLog and IC-756PRO III
> To: Andrei Nevis <v49a@yahoo.com>, rtty@contesting.com
> Message-ID: <7.0.0.16.2.20060401074052.0238a950@copper.net>
> Content-Type: text/plain; charset="us-ascii"; format=flowed
>
> ORIGINAL MESSAGE:
>
> At 05:41 AM 4/1/2006, Andrei Nevis wrote:
>
> >That is interesting.
> > My PRO-3 works Only when I mark 756 PRO in the Writelog Setup.
> > I tried to mark all other Radios with all Baud rates - only PRO 3
> > with 9600 Baud works.
> > 73's Andrei EW1AR-NP3D
> >
>
> *********** REPLY SEPARATOR ***********
>
> Did you also change the address in the radio? The default for the PRO
> III is 6E. Try changing it to 66 and tell WriteLog it is an IC-746PRO
> and it should work.
>
> The baud rate is independent of the address.
>
> 73, Bill W6WRT
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|