This fellow keeps sending me direct emails asking
to remove him from the list. Can anyone help him?
I've already suggested he follow the directions
at the top of each list mail.
73
Tom NU4G
Begin forwarded message:
> From: "huffew@myway.com" <huffew@myway.com>
> Date: May 8, 2005 7:53:03 PM CDT
> To: r390a@bellsouth.net
> Subject: Re: [RTTY] Rigblaster- worth the money?
> Reply-To: huffew@myway.com
>
>
>
> please remove me from your mailing list
>
>
>
>
> --- On Sun 05/08, Tom Norris < r390a@bellsouth.net > wrote:
> From: Tom Norris [mailto: r390a@bellsouth.net]
> To: huffew@myway.com
> Date: Sun, 8 May 2005 13:20:35 -0500
> Subject: Re: [RTTY] Rigblaster- worth the money?
>
> It's not my mailing list.<br><br>At the top of each RTTY list
> message are instructions<br>on how to
> unsubscribe.<br><br><br><br>On May 8, 2005, at 9:45 AM,
> huffew@myway.com wrote:<br><br>><br>> please remove me from your
> mailing list<br>><br>><br>><br>><br>> --- On Sat 05/07, Tom Norris
> < r390a@bellsouth.net > wrote:<br>> From: Tom Norris [mailto:
> r390a@bellsouth.net]<br>> To: rtty@contesting.com<br>> Date: Sat, 7
> May 2005 11:42:21 -0500<br>> Subject: Re: [RTTY] Rigblaster- worth
> the money?<br>><br>> Bill and the group.<br><br>I use a Signal Link
> SL-1+<br><br>Not <br>> only did it cost less, but it doesn't use
> up a com port.<br>It has <br>> it's own "vox" circuit built in,
> just connect to your<br>rig, hook <br>> up audio in/out, and
> you're ready to go.<br><br>As for homebrew, <br>> the circuit is
> very simple for this and<br>any of the other <br>> interfaces.
> Couple of small transformers<br>to isolate audio, an <br>>
> optoisolator if you are using a comm port<br>to
> provide TX, if not <br>> a small audio amp ckt to detect tone
> and<br>turn on a transistor <br>> switch.<br><br>73<br><br>Tom
> NU4G<br><br>> My main interest with a <br>> rigblaster or similar
> interface is the fact <br>> that you<br>> <br>> can have multiple
> features in one box. The way my setup is now, I <br>> can<br>>
> either use CAT or digital modes, but not both. Lack of <br>>
> ports and <br>> such are<br>> keeping me from using rig control
> <br>> while going digital. I have <br>> tried several<br>> <br>>
> configurations and none seem to work as of yet. And yes, my CI-V
> <br>> <br>> unit is<br>><br>>
> homebrew.<br>><br>_______________________________________________<br>R
> <br>> TTY mailing list<br>RTTY@contesting.com<br>http:// <br>>
> lists.contesting.com/mailman/listinfo/rtty<br><br>><br>>
> _______________________________________________<br>> No banners. No
> pop-ups. No kidding.<br>> Make My Way your home on the Web -
> http://www.myway.com<br>><br>><br>><br><br>
>
> _______________________________________________
> No banners. No pop-ups. No kidding.
> Make My Way your home on the Web - http://www.myway.com
>
>
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|