Good tip from K9MI. I keep forgetting about the hole in the bottom and just
force it out with the Command-C's from a term program. The only problem
with pulling the jumper is you loose your settings.
73, Dick - AA5VU
On 6/17/04 12:15 PM, "Mike Brown" <k9mi@sbcglobal.net> wrote:
> Bob, if Richard's idea doesn't work, you should be able to set
> the PK 232 back to factory defaults by pulling off the jumper on
> the underneath side of the 232. Easy to see, there's a hole
> there, and you can use tweasers or needle nose pliers to remove
> the jumper. I think the book says to leave it off 5 minutes.
> This "should" get you back to factory defaults and get your cmd:
> prompt back.
>
> 73, Mike K9MI
>
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|