RTTY
[Top] [All Lists]

Re: [RTTY] need help interfacing TS850 to Hal DXP38

To: <kevin@kd1j.com>, <rtty@contesting.com>
Subject: Re: [RTTY] need help interfacing TS850 to Hal DXP38
From: "Tom Homewood" <w1to@adelphia.net>
Date: Fri, 12 Mar 2004 09:47:07 -0500
List-post: <mailto:rtty@contesting.com>
Check the connections very carefully before you order. (wiring diagram).

The Kenwood cables don't support FSK as advertised.

Tom, W1TO


----- Original Message -----
From: <kevin@kd1j.com>
To: <rtty@contesting.com>
Sent: Friday, March 12, 2004 9:39 AM
Subject: Re: [RTTY] need help interfacing TS850 to Hal DXP38


>
>   I noticed that the www.buxcomm.com website has available a
> ready-made (one-end) 13 pin DIN cable to make things a little
> easier...
>
> 73,
> Kevin
>
>   <><><><><><><><><><><><><><>
>   Amateur Radio Station - KD1J
>   Kevin D. Jacobson
>   27 Ridge Road
>   Wallingford,    CT.    06492
>   e-Mail:       kevin@kd1j.com
>   Website: http://www.kd1j.com
>   <><><><><><><><><><><><><><>
>
>
>
> On Thu, 11 Mar 2004 22:58:13 -0700, "David Hachadorian" wrote:
>
> >
> >
> > ----- Original Message -----
> > From: "David Ashworth" <fathom@Access4Less.net>
> > To: <RTTY@contesting.com>
> > Sent: Thursday, March 11, 2004 9:27 PM
> > Subject: [RTTY] need help interfacing TS850 to Hal DXP38
> >
> >
> > > Hello, decided to go with a HAL.  Been looking over the manuals for
each
> > > piece of equipment and not quite clear on the hookup.  This is what I
> have
> > > come up with: FSK jack on Hal to RTTY jack on TS850 with RCA plugs,
AF
> > OUT
> > > jack on HAL to TS850 ACC2 pin 3 ,  AF IN jack on HAL to TS850 ACC2 pin
> 11.
> > > The Hal also has a PTT jack, would that go to pin 9 on ACC2?  Thanks
in
> > > advance for your help, Dave, NC6P.
> > >
> >
> > I hate that 13 pin din on the 850.
> > The male connector is hard to find, the pins are
> > close together, and it is susceptible to
> > rfi.
> >
> > I take the audio off the speaker output. Yes,
> > you have to pay attention to the af gain control.
> > If you are using FSK, you don't need audio in
> > (unless you are doing psk31 or some foolishness
> > like that).
> > If you need a ptt, You can use the mic connector
> > on the front panel. It works in all modes. Some
> > software control programs can do a software
> > ptt over the radio control line.
> >
> > Dave Hachadorian, K6LL
> > Yuma, AZ
> >
> > _______________________________________________
> > RTTY mailing list
> > RTTY@contesting.com
> > http://lists.contesting.com/mailman/listinfo/rtty
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>