RTTY
[Top] [All Lists]

[RTTY] Re: [WriteLog] AA5AU WriteLog Website Update

To: <rtty@contesting.com>
Subject: [RTTY] Re: [WriteLog] AA5AU WriteLog Website Update
From: aa5au at bellsouth.net (Don Hill AA5AU)
Date: Wed Feb 5 13:22:01 2003
If you use DXTelnet to send spots to WL, then you can filter spots.
Within DXTelnet, set your filter to send only spots containing the words
"rtty" or "wpx".  You will miss spots that don't contain these words, but
most people put these words in the comments section.

Or you can filter the spots by frequency range.  This may be better, but
you will get anything spotted within the range you set.  CW and SSB spots on
40M will also be sent through if they fall within the range set, such as 
7030-7100 khz.

To find out how to use DXTelnet with WL on a single computer, check out
http://www.qsl.net/wa9als/dxtelnet.htm.  To find out how to run DXTelnet to
WL over a LAN check out http://www.geocities.com/writelog/.

73, Don AA5AU

----- Original Message -----
From: "Jim McDonald" <jim@n7us.net>
To: "FireBrick" <w9ol@billnjudy.com>; <writelog@contesting.com>; "Dave 
Hachadorian" <k6ll@juno.com>; "RTTY Reflector"
<rtty@contesting.com>
Sent: Wednesday, February 05, 2003 6:26 AM
Subject: Re: [WriteLog] AA5AU WriteLog Website Update


> If you use an AR-Cluster you can limit the spots you receive to only RTTY.
> Here's the on-line manual section for filters:
> http://www.ab5k.net/ArcDocs/UserManual/ArcFilters.htm#DxBandMode
>
> But you might miss some spots using the band-mode filters in a RTTY contest.
> The reason is that the AR-Cluster program uses a frequency list that
> specifies the frequency ranges are assumed to be RTTY.  For 20, it's
> 14070-14150, and 40 is 7040-7100.  For non-contest periods that seems fine,
> but stations outside of those ranges would be missed.  The ranges can be
> changed by the sysop.
>
> I don't think many (any?) of my users use band-mode filtering.  If there's
> interest, I can change the RTTY ranges to whatever RTTY contest ops want
> them to be - just let me know.  Anyone is welcome to connect.  The system is
> stable, though my ISP, Sprint Broadband Direct, seems to be the weak link,
> in case you get disconnected.
>
> I only carry spots from US/VE stations, but I can change that if there's
> enough demand, especially if it's for a good cause, like a RTTY contest
> weekend.  Users not wanting spots from outside the US can filter them out.
>
> Let me know soon.  Just type in n7us.net in place of an IP address in
> WriteLog.
>
> Jim McDonald - N7US
> Mesa, Arizona
> jim@n7us.net
>
> N7US AR-Cluster:
> telnet://n7us.net
>
>
>
>
>
> ----- Original Message -----
> From: "FireBrick" <w9ol@billnjudy.com>
> To: <writelog@contesting.com>; "Dave Hachadorian" <k6ll@juno.com>
> Sent: Wednesday, February 05, 2003 3:54 AM
> Subject: Re: [WriteLog] AA5AU WriteLog Website Update
>
>
> > Are there any Telnet sites that are especially good for
> > RTTY Contests? Should we focus on one in particular? Thanks.
> >
> > Dave Hachadorian, K6LL
> > Yuma, AZ
> >
> Great idea Dave
> A Packet Cluster that was specifically populated by RTTY type during the
> contest.
>
> Any of the Writelog users sponsor a cluster site?
> I'd suggest an AR or Spider cluster as they
> have built-in filtering features that would allow us to
> filter out all those obnoxious modes such as cw or ssb spots. :-))
>
> -----------------------------------------------------
> You need a Lifestyle change if: You took a fishing pole to Sea World.
> -----------------------------------------------------
>
> W9OL, Bill H. in Chicagoland
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>

<Prev in Thread] Current Thread [Next in Thread>