Thanks for the replies. One thing I have found so far using the MPFilter
program is that when in RTTY mode the selected filters are as follows
NOR both 2.4k
NAR1 both 2.0
NAR2 both 250
I thought narrow1 should select the 500Hz filters. I can swithch in the
different filters and see their effects using the Filter progam so I know
they are there, it is getting them switched in at the right time which is
confusing me.
Jim
----- Original Message -----
From: "Jim Martin" <MM0BQI@thersgb.net>
To: "rtty" <rtty@contesting.com>
Sent: Thursday, January 02, 2003 9:43 AM
Subject: [RTTY] RTTY and FT1000MP Mk V
> Happy New Year everyone!
> I am having severe problems with the MkV and MMTTY on a busy band. When
a
> strong signal starts up many KC/s away the trace on the display drops
almost
> to zero and I have problems decoding the station I am listening to. The
> IC746 works much better so I assume I have messed up some settings. I
have
> tried IPO on/off and AGC off, both help but not enough.
> The MkV filters fitted are as follows
> 8.2 MHz 250Hz and 2.0KHz both Yaesu
> 455KHz 250 Hz(Yaesu) , 400Hz (Inrad), 1.8Khz (Inrad)
> 400Hz Inrad second RX
> I am using FSK with the mode set to RTTY.
> SSB and CW operation seems fine ( but maybe it should be better?)
> Any comments on menu set-up and filter selection would be appreciated
> because I am at my wits end with this one. I even looked at trading in
for
> a PRO!
> Thanks and see you all in RU
> Jim MM0BQI
>
>
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
|