RTTY
[Top] [All Lists]

[RTTY] SARTG GU0SUP - SOABLP

To: <rtty@contesting.com>
Subject: [RTTY] SARTG GU0SUP - SOABLP
From: Phil Cooper" <pcooper@guernsey.net (Phil Cooper)
Date: Sun, 18 Aug 2002 18:12:09 +0100
Hi all,

Well, that was fun! And the best bit was I worked a new country - OA and not
just once, but on TWO bands as well! My sincere thanks to OA4AHW for that
feat, and a card will be sent direct!

I had a few problems this time, and I am not sure why! OK, the computer
didn't like me playing on 80m very much, and that wasn't too much of a
surprise.
The real problem was that the computer kept telling me it was low on
resources (I know, get XP!), and I only had WL running!
Every now and again, the highlighting would stop, and if I didn't do a
re-boot then, it froze on me.
I have a few ideas, and will do a full Norton check in the week, just to see
if it shows up any problems.

Does anyone know the easiest way to create a "single band" entry within
Writelog (as per rules) as I fancy entering 15m as a single band.
Highlights:
Well, the OA for sure, but the rest was just the usual fun.
Lowlights:
Missing Dick SV9/G3URA was one, and not getting K6RLL either. I didn't see
any W7's, and W8 was pretty rare here as well. 10m was pretty quiet, and I
did a lot of band hopping to make the most of it. Even 15 and 20 seemed
quite noisy here.

Here is my effort:
Single OP., All Band  (Low power)

           QSOs     Points     DX:     Call Areas
80m:      4             40         3             0
40m:     36         395         21             4
20m:     157       1790        47             12
15m:     102        1210        37             11
10m:      24         290         19              1
Total:  323      3725

Total multipliers: 155
Score:  577375
Station Description:  IC756
Antenna(s):   half G5RV
Operators:   GU0SUP

Club:    BARTG


Hope you all enjoyed it too!
Very best 73 de Phil GU0SUP

Phil Cooper, GU0SUP
1 Clos au Pre
La Hougue du Pommier, Castel
Guernsey, UK, GY5 7FQ




<Prev in Thread] Current Thread [Next in Thread>