Thanks for all the replies. Sorry couldn't respond individually
as there were quite a lot of them. The problem has been resolved
by moving the Shift-width control
73, Don AA5AU
----- Original Message -----
From: "Don Hill AA5AU" <aa5au@bellsouth.net>
To: "RTTY Reflector" <rtty@contesting.com>
Sent: Saturday, August 03, 2002 6:18 PM
Subject: [RTTY] FT-1000D LSB RTTY settings
> Working with someone trying to get RTTY working using AFSK
> to an FT-1000D. He can transmit high tones but can't receive high tones.
> He can receive down around 1200 hz. He is using the radio in the LSB
> position.
>
> What's the trick to receiving high tones (2125/2295 hz) with this radio
> in the LSB position? Do you have to use the LSB position when using
> AFSK?
>
> I'm guessing it's a filter setting. I suggested also that he could use low
> tones, but I've never used low tones, so don't know what to tell him about
> that route.
>
> Thanks,
> Don AA5AU
> http://www.aa5au.com
> http://www.geocities.com/writelog
>
>
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
|