Sorry, not what I meant. The worst one was 1/16 of a turn from where
they wound up when plier-tight. That is, it *was* hand-tight
73, Pete N4ZR
On 9/24/2023 11:19 PM, Frank W3LPL wrote:
Hi Pete,
A PL-259 backed 1/16th of a turn from fully hand tightened
is a very unreliable connector.
Get in the habit of tightening all of your PL-259s just tight enough
so they cannot be loosened by hand and all of your loose PL-259
issues will be forever eliminated.
73
Frank
W3LPL
------------------------------------------------------------------------
*From: *"Pete N4ZR N4ZR" <pete.n4zr@gmail.com>
*To: *"Frank W3LPL" <donovanf@starpower.net>, "RFI List"
<rfi@contesting.com>
*Sent: *Sunday, September 24, 2023 6:01:39 PM
*Subject: *Re: [RFI] Weird RFI Episode
I wish I could tell you I found a "loose" PL-259, Frank - I think the
most I took up on any of them was about a sixteenth of a turn.
Fortunately, at 100 watts, carnage was nil. I have a hunch that
yesterday's torrential rain may have been implicated, because a couple
of the connectors are sheltered but not waterproofed and may have
gotten wet.
73, Pete N4ZR
On 9/24/2023 7:15 PM, Frank W3LPL wrote:
Hi Pete,
As you know, that's exactly why I recommend that PL-259 connectors
always be lightly wrench tightened, just enough to make it not
removable by hand, no more.
Next, check you entire station to verify that all of your PL-259
connectors can not be removed by hand
You were fortunate that no damage was caused by the loose PL-259
When shield integrity is broken, the return circuit must take an
alternative path that can do lots of damage.
73
Frank
W3LPL
----- Original Message -----
From: "Pete N4ZR N4ZR"<pete.n4zr@gmail.com> <mailto:pete.n4zr@gmail.com>
To: "RFI List"<rfi@contesting.com> <mailto:rfi@contesting.com>
Sent: Sunday, September 24, 2023 3:16:20 PM
Subject: [RFI] Weird RFI Episode
This morning I got up and went on the air in the CQWW RTTY Contest.
Everything had been fine yesterday, but as soon as I made my first
transmission, both of my monitors shut down. Eventually, I found that
the cause was RFI - anything over about 40 watts and blooey (the
computer was fine). Without a lot of excruciating detail, I think the
cause was a hand-tight PL-259 somewhere in my feedline out to my antenna
switch. Initially it looked fjne, and then it started showing me high
SWRs on all bands. I snugged them all down and it went away.
This is a first to me in some 40 years of playing radio and computers.
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|