RFI
[Top] [All Lists]

[RFI] Noise Level During Power Outage

To: "rfi@contesting.com" <rfi@contesting.com>
Subject: [RFI] Noise Level During Power Outage
From: K9MA <k9ma@sdellington.us>
Date: Tue, 31 Jan 2023 23:21:42 -0600
List-post: <mailto:rfi@contesting.com>
My QTH is in an older residential area, surrounded by overhead power lines. Line noise is a constant problem. We recently had a major power outage, so I measured the noise levels to get a baseline with little line noise. (See below, assuming it comes through.) The outage was pretty large: there was no power within a kilometer or so, perhaps further to the west. The levels I measured shortly after power was restored the next morning are fairly typical lately. To the NE, it wasn't so bad, only increasing 5-8 dB when the power came on. West was much worse, 7-19 dB. I've long known there was a major noise source to the west. I guess it's time to track it down.

I suspect these levels are fairly typical of a residential area with overhead lines. They would probably be worse if I hadn't been doing battle with the utility for the past 30 years to get the worst of the sources fixed. One thing this data shows, which I've long suspected, is that the distribution lines are the major source of noise. There are some transmission lines just a few hundred meters away, but I've never traced any significant noise to them.

It may say something about the sad state of our utility's infrastructure: A car knocked down a pole about 1 km from my QTH, and it took out the power up to 2 km away, with power surges causing extensive damage to appliances, etc. (None at my place.) Just down the street, far from the downed pole, we had a major fireworks show and nearby a transformer exploded. Apparently, similar things happened throughout the affected area. Did they forget the fuses?

73,

Scott K9MA

--
Scott Ellington
Madison, Wisconsin, USA

scott@sdellington.us


K9MA    
        
        
        
23.01.28 Noise Levels   
        
        
        
Major power outage      
        
        
        
MT, K4, 10 kHz span, 7 dB rx path loss  
        
        
        
Resolution bandwidth 11 Hz      
        
        
        

        
        
        
        
Frequency       Bearing         Power Out       Power On        
14      45      -135    -130    dBm
270     -139    -120    
21      45      -141    -133    
270     -140    -127    
28      45      -148    -141    
270     -146    -139    

--
Scott  K9MA

k9ma@sdellington.us
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>