I also use high voltage input coupling capacitors on my preamps. This is a
trick I learned by the CATV industry.
Mike N2MS
> On 09/18/2021 7:35 AM Dave <dave@nk7z.net> wrote:
>
>
> Thanks gents... The resistors I am using are 10 M, 20KVs. I will build
> a small chassis and put them on inside, with a pair of SO-239s.
>
> 73, and thanks,
> Dave (NK7Z)
> https://www.nk7z.net
> ARRL Volunteer Examiner
> ARRL Technical Specialist, RFI
> ARRL Asst. Director, NW Division, Technical Resources
>
> On 9/17/21 6:25 PM, Jim Brown wrote:
> > On 9/17/2021 5:54 PM, David Eckhardt wrote:
> >> The value is anything over 10 kohms. The disturbance
> >> to the 50-ohm impedance is completely negligible. The rule-of-thumb
> >> on the
> >> resistor value is something over 10X the system impedance. I've even
> >> used
> >> 1k successfully.
> >
> > A limiting factor for low values is dissipation in the bleed resistor.
> >
> > 73, Jim K9YC
> > _______________________________________________
> > RFI mailing list
> > RFI@contesting.com
> > http://lists.contesting.com/mailman/listinfo/rfi
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|