Jim,
The 60 watts is due to the switch supporting 4 POE ports at ~1/2 amp a
port + some power overhead for the switch it self. They do have a 8
port switch I think that does not support POE that uses a 12 volt supply
(I Think).
I am planning on powering my Access points, and some cameras from my
switch suppling power via ethernet.
Chuck K9LC
On 3/25/2020 12:24 PM, Jim McCook wrote:
Gedas, I forgot to mention that it's a 60w switch, so most likely a 2w
supply would do the job. Chuck seems to have the answer... in that
the problem is internal with the switch itself. That suggests the
only solution is to replace it with something else, but I know the
owner won't do that. I'll make an attempt to contact the mfr,
Ubiquiti, but I doubt that will do any good. It seems to be another
RFI dead end, unfortunately. Hard to keep up with this stuff!
73, Jim
W6YA
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|