Follow-up: This source arced itself out Friday (the 15th).
It was down to only S9+10 dB from its onset Tues night at S9+30 dB. It had also
become intermittent.
Also, the Status LED no longer shows activity, indicating this unit is now out
of service. The other IntelliRupter devices in the area continue to show a
blink every 30 seconds.
73, Jim WB5WPA
From: JW via RFI <rfi@contesting.com>
To: "rfi@contesting.com" <rfi@contesting.com>
Sent: Wednesday, February 13, 2019 10:34 AM
Subject: [RFI] A new one-"IntelliRupter, PulseCloser, Fault Interrupter"
internal arcing
ONCOR appears to be implementing an actual Smart Distribution Grid in some
parts of the north central Texas service area as opposed to the usual
substation hub, spoke and wheel topology. All well and good, I suppose.
But one of their installs became quite noisy last night, about the time some
residents in the area reported power going out or glitching in other cases; I
saw none of that, just a LOUD noise that started on 160 meters about the time
the foregoing power outages took place. These facts were ascertained after the
fact via multiple posts to nextdoor.
Cutting to the chase - here is what it sounds like, and yes, that is nearly 30
dB over S9 in SSB on 160 meters (40 over in AM mode). 80 meters is just as bad
or worse. The noise extends up past and through the 40 meter band as observed
at my QTH 1/4 mile away. The AM broadcast band is affected all up and down Park
Place Drive and as well as any street with a lateral off that 3-phase feeder.
https://youtu.be/332YiVEXvjw
Here is a pdf of the device:
https://www.sandc.com/globalassets/sac-electric/documents/sharepoint/documents---all-documents/descriptive-bulletin-766-30.pdf
Here is what they look like out in the field:
https://forums.qrz.com/index.php?threads/lots-of-broken-or-missing-ground-wires-on-local-power-poles.646286/page-5#post-4967605
Also noteworthy (knowledge in the right hands can work wonders) is a "Status"
L.E.D. that can be seen on the bottom of the unit to "flash" once every 30 secs
or so on a (presumed) properly operating IntelliRupter, and last night the
L.E.D. on this unit was flashing rapidly at about a 1 Hz rate.
This morning, a check of two other IntelliRupters showed the same once every 30
secs flash rate. The 'failed', noisy unit showed no L.E.D. activity whatsoever.
No visible external arcing could be seen this morning on a check about 6 AM
local.
73,Jim WB5WPA
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|