Ken,
As I recall, the CAT5 or CAT6 specifications do not actually specify that each
pair have a different number of twists per inch. They do specify that all pairs
be less than 38mm per twist and that pair twist lengths shall be chosen to
ensure compliance with the transmission requirements of the standard. In
practice, I believe manufacturers are using different twists per inch on the
wire pairs in order to meet the specifications for cross-talk.
At any rate, I don’t believe the original question was concerning Ethernet
cable.
Reference https://www.physicsforums.com/threads/cat6-versus-cat5.246719/
73,
Bob Nobis
n7rjn@nobis.net
> On Dec 30, 2016, at 20:22, Kenneth G. Gordon <kgordon2006@frontier.com> wrote:
>
> On 30 Dec 2016 at 19:33, Robert Nobis wrote:
>
>> I have never seen anything on number of turns.
>
> I have: with regard to CAT-5 cable. The number of turns varies between pairs
> in order to
> reduce cross-talk between pairs.
>
> I cannot remember where I saw this, but I was an IT Professional for over 30
> years.
>
> Maybe if we looked in the computer networking field.
>
> Ken W7EKB
>
>
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
>
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|