Dennis,
Just noticed your msg from last week in the inbox.... Had to service abt
900 other msg.'s hihi.
The sensor can be as simple as a small loop of wire from the center
conductor tied back to ground.
I made up a BNC female with 3" alligator leads and a 20' length of RG 58
coax. I then take a 12" insulated wire loop it around a bathroom TP empty
roll. Also I use a length of 1/2" PVC tube with the coax taped to the PVC -
You can move the wand under the vehicle or in various parts of the engine
compartment to sniff around. Hope this helps.
73
PeterV [REN] WB3FSR
=========================================
Peter D. Vouvounas Ofc: 732-701-1130
McLeod USA Cell:732-674-4001
98 Meridian Dr.
Brick, NJ 08724
Mailto: wb3fsr@home.com
InterActive 2way: wb3fsr@imcingular.com
=========================================
|