At 01:32 PM 11/19/01 -0600, Wendell Wyly W5FL wrote:
>Kris, I used the European RFI Standard (CE02 I believe) which addresses both
>radiated and susceptibility) as my basis for selecting a monitor. The
>Mitsubishi Diamond Pro 87TXM cannot be heard in my FT1000MP setting 2 inches
>away. The feed lines are RG217 and the tower is located approximately 30
>feet from the station. My old monitor had to be turned off to operate some
>bands and frequencies. I would think an LCD display would be pretty clean,
>but their picture quality leaves a lot to be desired in terms of the
>legibility of small characters, etc.
Wendell, is conformance with this spec required in order to put the CE seal
on a monitor? Put another way, can one be sure that any computer that
shows the CE seal has met this standard? Or do you have to go digging in
the instruction book, specs, etc?
73, Pete N4ZR
www.qsl.net/n4zr
|