Orion
[Top] [All Lists]

Re: [Orion] Orion display issue

To: Duane A Calvin <ac5aa@juno.com>
Subject: Re: [Orion] Orion display issue
From: Joe Giacobello <k2xx@swva.net>
Reply-to: k2xx@swva.net
Date: Sat, 08 Apr 2006 11:59:56 -0400
List-post: <mailto:orion@contesting.com>
That sure makes sense!

Duane A Calvin wrote:

>Joe,
>        If your main tuning encoder works for tuning, and the only place
>it doesn't work is the menu selection, then something else is wrong.  One
>of the TT service guys could probably help a lot on this one!
>
>        73,  Duane
>
>
>On Fri, 07 Apr 2006 12:47:43 -0400 Joe Giacobello <k2xx@swva.net> writes:
>  
>
>>John, I spoke too soon.  The highlighted line in every menu is now 
>>totally immobile whether using the front panel Main knob or the knob 
>>on 
>>the remote pod.  Since I use the N4PY software, I don't need this 
>>function most of the time.  Nevertheless, does that still point to 
>>the 
>>encoder as the source of the problem?
>>
>>Thanks for the link to the site with the encoder repair.  It may 
>>well 
>>come in handy.
>>
>>73, Joe
>>
>>John (KE5C) wrote:
>>
>>    
>>
>>>>John, thanks for your input.  Well, the low contrast setting still 
>>>>        
>>>>
>>persists
>>    
>>
>>>>   
>>>>
>>>>        
>>>>
>>>(You should pardon the expression.), but it looks like the weird 
>>>      
>>>
>>behavior of the
>>    
>>
>>>selection (Main) knob must arise from a faulty encoder or the like. 
>>>      
>>>
>> The
>>    
>>
>>>selection process works fine with the remote pod's knob.
>>>
>>>i assume you did the v2 mod.  when you had the front off, it's 
>>>      
>>>
>>possible you
>>    
>>
>>>didn't get one of those jumpers from the encoder to the board fully 
>>>      
>>>
>>seated.  you
>>    
>>
>>>also might be able to talk tt into sending you an encoder, and 
>>>      
>>>
>>replacing just a
>>    
>>
>>>few steps more than doing the v2 mod in the first place:
>>>
>>>      
>>>
>>http://www.bosshardradio.com/gallery/view_photo.php?set_albumName=orion_
>>    
>>
>rit&id=meter_a_b_encoders
>  
>
>>>(url also attached)
>>>
>>>just take the knob off from the front, remove the four mounting 
>>>      
>>>
>>screws, and the
>>    
>>
>>>big encoder comes free.
>>>
>>>73, john
>>> 
>>>
>>>      
>>>
>>_______________________________________________
>>Orion mailing list
>>Orion@contesting.com
>>http://lists.contesting.com/mailman/listinfo/orion
>>
>>
>>    
>>
>
>
>--------------------------------------
>Duane Calvin, AC5AA
>Austin, Texas
>
>http://home.austin.rr.com/ac5aa
>
>
>  
>
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion

<Prev in Thread] Current Thread [Next in Thread>