In einer eMail vom 29.11.2005 22:00:18 Westeuropäische Normalzeit schreibt
n4py@arrl.net:
The ALC in the Orion is internal only. There is no external ALC on any
tentec radio. You simply adjust the "PWR" level on the Orion for the
correct drive level when in CW mode. Then in SSB, the drive level will
never be more than this value. You then adjust the mic gain level until the
red ALC light on the Orion flickers on voice peaks. This will never
overdrive your amplifier as long as the steady state PWR level is correct
for CW mode.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: <Milan Gütter>; "OK1FM" <ok1fm@ges.cz>
To: <orion@contesting.com>
Sent: Tuesday, November 29, 2005 3:53 PM
Subject: [Orion] Orion - how with ALC?
It seems to me very dangerous:
If you are at "High Power", 100W, for working barefoot and then push the
Tune switch (should be 20W), tuning starts with 100W and then -slowly- power
goes down to 20 W.
The same situation is, if you send with 100 W, then switch to RX, reduce
power to a suitable level (let say: 50W for PA-driving) and TX again: You will
start transmitting with full power, and the rig reduces slowly to 50W.
I never had problems with my amp, it seems to be bulletproof. But i would
not like to do this with a transistorized amp.
Vy 73, Randolf, DL6KAI
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
|