Orion
[Top] [All Lists]

[TenTec] FT9000 ETR available

To: tentec@contesting.com, orion@contesting.com
Subject: [TenTec] FT9000 ETR available
From: Bill Tippett <btippett@alum.mit.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 13 Nov 2005 07:10:16 -0500
List-post: <mailto:tentec@contesting.com>
         Some interesting comments by Rob Sherwood
after reviewing ARRL's ETR for the 9000 here:

http://groups.yahoo.com/group/FTdx-9000/message/619

A few excerpts:

As one would expect, once one is inside the 3 kHz roofing filter, the
dynamic range is 70 dB, like any FT-1000 series.
The Orion blows it out of the water in close-in dynamic range.
The inband IMD on receive is terrible with strong signals. 30% IMD
distortion at S9 +60 dB.
5% inband IMD distortion at S9 +40. Inband IMD should be 1% or less.
My S-Line started out about this level of inband IMD, regardless of signal
level, but after modifying the Collins circuit, I got it down to 1%.
The Collins sound great now, but sounded like garbage when the IMD was up in
the 10% to 20% range.
Microtune front end has 6 to 8 dB insertion loss.
Where is the bandwidth data on the microtune front end?
Some of the tables have strange blocks that are blank.
In respect to close-in dynamic range (DR3), the radio performs as one would
expect give the 3 kHz bandwidth roofing filter.
Only one measurement is made of close-in DR3 at 1 and 2 kHz, and that with
the preamp on.
Strange looking transmit IMD in class A. Wide-spaced it is clean, but lots
of close in "sticks" on the spectrum analyzer plot that should not be there.
Just a note, at 2 kHz the DR3 of the 9000 is 4 dB better than a 30 year old
Sherwood modified R-4C.
At 1 kHz the 9000 DR3 is 10 dB worse than a Sherwood modified R-4C.

         Rob also has a new paper on receiver performance
that I have not seen before:

http://www.sherweng.com/images/MeasurementAccuracy&SampleVariation.pdf

                                         73,  Bill W4ZV 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] FT9000 ETR available, Bill Tippett <=