1 stop bit worked, which I got from the Programmer's Guide. NU1U told me to
check CTS, which did the trick.
This information shouldn't be buried in a programmer's guide on another web
site (and the CTS wasn't there); it should be in the manual in a section on
interfacing to logging or control programs.
Thanks, Barry.
Jim N7US
-----Original Message-----
From: Barry N1EU [mailto:n1eu@yahoo.com]
Sent: Saturday, March 12, 2005 5:17 PM
To: Jim McDonald; Dxbase@mailman.qth.net; orion@contesting.com
Subject: Re: [Orion] FW: Orion serial parameters
Try 2 stop bits.
73,
Barry N1EU
--- Jim McDonald <jim@n7us.net> wrote:
> I can't get DXbase to talk to my new Orion. I am
> using 57600/8/N/1 but
> nothing. Have tried a native serial port,
> previously used for my PROII, and
> a Belkin USB/serial converter but no luck. Any
> suggestions?
>
> Jim N7US
>
>
>
>
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
>
__________________________________
Do you Yahoo!?
Make Yahoo! your home page
http://www.yahoo.com/r/hs
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
|