To: | orion565@yahoogroups.com, orion@contesting.com,tentec@contesting.com |
---|---|
Subject: | [TenTec] Sweep Questions |
From: | "Richard Detweiler" <rdetweil@hotmail.com> |
Reply-to: | tentec@contesting.com |
Date: | Mon, 08 Mar 2004 08:51:22 -0600 |
List-post: | <mailto:tentec@contesting.com> |
Hi Fellow Orion users, I am wondering if anyone else is having sweep lock up problems under V1.369 of the micro code. The rig only quits RX & TX when the Sweep locks up, Next to the Send 2 button is a message "DSP T/O 0" message and the sweep display is blank. Most of the control functions seem to work, but can not hear an signal, or transmit. I use logging software that is polling the rig, about every 500 ms. This has occurred both During CW and SSB contacts. Usually within 10 minutes into using the sweep. If no one else is seeing this, then perhaps I have a bad logic board, If others are seeing this then I need to get a patch... Thanks for your replies. 73's Rich K5SF _________________________________________________________________ One-click access to Hotmail from any Web page ? download MSN Toolbar now! http://clk.atdmt.com/AVE/go/onm00200413ave/direct/01/ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [Orion] Re: Jupiter vs ORION, john, ke5c |
---|---|
Next by Date: | RE: [Orion] Re: Jupiter vs ORION, Kamar |
Previous by Thread: | [Orion] Re: Jupiter vs ORION, Allan Henry Kaplan |
Next by Thread: | RE: [Orion] USING ORION'S RECEIVER, Tom Wagner |
Indexes: | [Date] [Thread] [Top] [All Lists] |