This is a multi-part message in MIME format.
------=_NextPart_000_0012_01C173B7.A361F580
Content-Type: text/plain;
charset="iso-8859-1"
Content-Transfer-Encoding: quoted-printable
Gentlemen, I can't seem to get 10.53 to follow my radio from band to =
band. I have a cable from the CAT connector on the MP to COM 1 of the =
computer. The CAT indicator is coming on every few seconds so I assume =
the radio is being interrogated by the computer. I made sure the serial =
port was set to 4800 baud and even went into "my computer" to make sure =
the IRQ and address were correct. I did notice at that time the speed =
selected for the port was 9600 baud, so I changed it in "my computer" to =
4800. The CW keying and antenna control are both LPT1. The program sends =
CW just fine and keys the radio with no problem. The LPT1 of the =
computer is connected to J1 connector on the Top-Ten Band Decoder. I =
assumed that when I change bands on the radio the radio would tell the =
computer via COM 1 and the computer would change the antenna via LPT 1 =
and also move the program itself to the new band. That does not happen. =
Perhaps I have simply done something foolish or am overlooking the =
obvious. Any input will be appreciated. Steve, NN4T.
------=_NextPart_000_0012_01C173B7.A361F580
Content-Type: text/html;
charset="iso-8859-1"
Content-Transfer-Encoding: quoted-printable
<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META http-equiv=3DContent-Type content=3D"text/html; =
charset=3Diso-8859-1">
<META content=3D"MSHTML 5.50.4207.2601" name=3DGENERATOR>
<STYLE></STYLE>
</HEAD>
<BODY bgColor=3D#ffffff>
<DIV><FONT face=3DArial size=3D2>Gentlemen, I can't seem to get 10.53 to =
follow my=20
radio from band to band. I have a cable from the CAT connector on the MP =
to COM=20
1 of the computer. The CAT indicator is coming on every few seconds so I =
assume=20
the radio is being interrogated by the computer. I made sure the serial =
port was=20
set to 4800 baud and even went into "my computer" to make sure the IRQ =
and=20
address were correct. I did notice at that time the speed selected for =
the port=20
was 9600 baud, so I changed it in "my computer" to 4800. The CW keying =
and=20
antenna control are both LPT1. The program sends CW just fine and keys =
the radio=20
with no problem. The LPT1 of the computer is connected to J1 connector =
on the=20
Top-Ten Band Decoder. I assumed that when I change bands on the radio =
the radio=20
would tell the computer via COM 1 and the computer would change the =
antenna via=20
LPT 1 and also move the program itself to the new band. That does not =
happen.=20
Perhaps I have simply done something foolish or am overlooking the =
obvious. Any=20
input will be appreciated. Steve, NN4T.</FONT></DIV></BODY></HTML>
------=_NextPart_000_0012_01C173B7.A361F580--
|