John,
Are you using 10.00 or a later version?
Use CONFIG.EXE, in the NA directory. This will allow you to choose
equipment and configure ports, baud, IRQ, etc.
73
Don
WX3M
----- Original Message -----
From: John Thompson <jwt105@yahoo.com>
To: <na-user@contesting.com>
Sent: Friday, September 28, 2001 8:28 PM
Subject: [NA-User] Pa QSO
> Getting ready for PAQ. Have version 10, no docs. How
> do I speify com port for radio, com port for keying
> line, and type of radio?
>
> 73,
>
> John K3MD
>
> __________________________________________________
> Do You Yahoo!?
> Listen to your Yahoo! Mail messages from any phone.
> http://phone.yahoo.com
> _______________________________________________
> NA-User mailing list
> NA-User@contesting.com
> http://lists.contesting.com/mailman/listinfo/na-user
|