I've got 10.34 running here on a 486/66, DOS only, version 6. Machine
now has 16M RAM.
The problem I'm having is when I am attempting to start a new QDF file
by going in and running NA and then naming my file..ie WWCW98.QDF. I
get to the point in the program where the window opens and asks if you
are running SO, SOA, MS etc. The program locks. I have to shut the PC
down and try again. Out of 10 times in trying last night, I finally got
it to take the info and move on.
Then program then prompts me to enter a CALL and QTH info, I do and the
program then moves down to the area for your name and address etc., the
program locks at that point. I have to re-boot.
I saw this for SS too but I only had to re-boot one time and didn't
really think too much of it. Last night, I was beginning to wonder if
was going to be able to use the program at all. It took about 45
minutes to finally get through the set-up procedure for this
weekend....it usally takes me about 2 minutes max.
I thought it might be a memory problem because I had only 4M in the PC
but I dropped in some extra SIMMs and am now at 16M with about the same
problems.
I have also gone back to older..ie 10.24, and this does not happen
there. As a last resort I was going to use 10.24 to make the QDF and
then swap out the NA.EXE if I had too, but never did.
Anyone else seen this?? Any clues??
Thanks
Greg
K9IG
--
Submissions: na-user@contesting.com
Administrative requests: na-user-REQUEST@contesting.com
WWW: http://www.contesting.com/datom/
Questions: owner-na-user@contesting.com
|