1. My Omni-VI is serial # 1A10263.
2. I have tried (as on page 66 of the Ver. 10 manual) as ICOM-735 and
as
ICOM-781. It doesn't work at all as a 735. The problems I have described
to you were setting it as shown for the 781.
3. On the reflector I recently said:
>While making a few contacts in the SSB NAQP last night, the program shut
>down with this message:
> "Error 05 occurred in module NA1013 at address 0726:0F51"
>I can restart the program normally using other QDF files, but always get
>this error message when attempting to restart the QDF for this contest. I
>would like to retrieve my log, but can't. Any help would be appreciated.
>Thanks.>
Then, Bob (N4BP) reminded me about the Utility for looking at a .qdf
(from
which I retrieved my log); and I replied to him:
>I had earlier problems during the CW NAQP. The Omni sometimes tunes in
>small "jerks" by jumping 15 to 35 Hz; and, on CW, it kept shutting down the
>keyers--both the NA memories AND the internal Omni-VI keyer. The Omni
>would not send at all until I quickly switched the rig off-on. Then it
>would go again for a while. On SSB, the VOX kept tripping to transmit.
>All the while on both modes, the bottom of the screen kept telling me that
>the rig was out of the contest band.
Earlier, I had forgotten to mention that operation is the same whether I
run the program under Windows 95 or from DOS.
I really appreciate your interest in this. Once more, thank you!
73, Charles
Charles W. Shaw, N5UL
Hobbs, NM
<n5ul@wtaccess.com>
--
Submissions: na-user@ve7tcp.ampr.org
Administrative requests: na-user-REQUEST@ve7tcp.ampr.org
WWW: http://www.ve7tcp.ampr.org/Lists/na-user.html
Questions: owner-na-user@ve7tcp.ampr.org
|