Rick,
Sure there is, I have done hundreds, maybe thousands :( over the last few
years!
1. Configure remote by IP address (type password)
2. Upload Software
3. Select proper bin file, consult system information to make sure
4. Check use existing key
5. OK
6. Continue with Upload if all looks ok "Yes"
7. Continue with Upload if all looks ok again "Yes"
8. File will load and unit will reboot
9. Done
DO NOT open the Config File and then Upload Software. I believe you will
lose the System Access Phrase doing it this way. Then you will be making
that service call anyways.
Give me a call tomorrow on my cell if you are unsure what I mean.
Rick Harnish
President
OnlyInternet Broadband & Wireless, Inc.
260-827-2482 Office
260-918-4340 VoIP
260-307-4000 Cell
www.oibw.net
rharnish@oibw.net
MSN: r_harnish62@hotmail.com
ICQ: 293578162
Founding Member of WISPA
-----Original Message-----
From: Rick Snider [mailto:rick@snider.org]
Sent: Wednesday, December 08, 2004 1:36 PM
To: karlnet@WISPNotes.com
Subject: [Karlnet] Upgrading to 4.46 - Remotely
Is there a safe way to do remote upgrades to KN105 and RG-1100 boards over
the radio link?
I assume loading in a Config File to the Bin before downloading would work.
But is there
a supported way to remotely upgrade the Bin to these boards?
Rick Snider, PE
Hillcountry Networks
Texas Rural Internet Engineering
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|