Karlnet
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

[Karlnet] KN-205 pass through of PoE voltages fromEthernet1toEthernet2

from [Joe Correia] [Permanent Link][Original]
To: karlnet@WISPNotes.com
Subject: [Karlnet] KN-205 pass through of PoE voltages fromEthernet1toEthernet2
From: Joe Correia <Joe@FallRiverOnline.com>
Reply-to: Karlnet Mailing List <karlnet@WISPNotes.com>
Date: Sun, 18 Jul 2004 21:20:53 -0400
List-post: <mailto:karlnet@WISPNotes.com>
It should be "J1" However http://www.karlnet.com/Documents/KN-105-KN-205%20Printed%20Circuit%20Board%20(PCB)%20User%27s%20Guide.pdf

doesn't say anything about J1. I could be wrong but I believe it's the 4 pins right next to J3.

--Joe




_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [Karlnet] KN-205 pass through of PoE voltages from Ethernet1toEthernet2, Norm Young
Next by Date:  Re: [Karlnet] KN-205 pass through of PoE voltagesfromEthernet1toEthernet2, Norm Young
Previous by Thread:  [Karlnet] Config Program?, Joe Correia
Next by Thread:  Re: [Karlnet] KN-205 pass through of PoE voltagesfromEthernet1toEthernet2, Norm Young
Indexes:  [Date] [Thread] [Top] [All Lists]