Karlnet
[Top] [All Lists]

RE: [Karlnet] Dual-Slot Sat - Only One Base?

To: "'Karlnet Mailing List'" <karlnet@WISPNotes.com>
Subject: RE: [Karlnet] Dual-Slot Sat - Only One Base?
From: "Jayson A. Baker" <jbaker@peakinet.net>
Reply-to: Karlnet Mailing List <karlnet@WISPNotes.com>
Date: Sun, 13 Jun 2004 19:10:52 -0600
List-post: <mailto:karlnet@WISPNotes.com>
Base A is Ch 1, ID 1.
Base 2 is Ch 11, ID 11.
And of course, the corresponding radios on the Satellite match.

Only will link with one, though.  Don't understand, at all.

Regards,
Jayson A. Baker
Peak Internet Solutions



-----Original Message-----
From: karlnet-bounces@WISPNotes.com [mailto:karlnet-bounces@WISPNotes.com]
On Behalf Of Paul Horak
Sent: Sunday, June 13, 2004 5:38 PM
To: Karlnet Mailing List
Subject: RE: [Karlnet] Dual-Slot Sat - Only One Base?

Hi Jayson,

Are you sure that everything is on different network
IDs? Perhaps TC is getting confused about what to
connect to? Hope this helps.

Cheers,

Paul

--- "Jayson A. Baker" <jbaker@peakinet.net> wrote:
> AP-1000 is "Base 1" (i.e. slot 1 on Sat).
> KN-205 is "Base 2" (i.e. slot 2 on Sat).
> 
> Both Base's have one card, slot 1, ISP Base, up to
> 64 sat, with very few
> sat's connected (i.e. not over 64 limit).
> 
> Regards,
> Jayson A. Baker
> Peak Internet Solutions
> 
> 
> 
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
> [mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of martin@belairinternet.com
> Sent: Sunday, June 13, 2004 12:30 AM
> To: karlnet@WISPNotes.com
> Subject: Re: [Karlnet] Dual-Slot Sat - Only One
> Base?
> 
> Which is base one and 2? does the sat AP-1000 have 2
> incomming links??
> 
> Please be more specific.
> 
> Martin Madsen
> 
> > Hi,
> >
> >
> >
> > Have two separate ISP Base's - one is an AP-1000,
> one is a KN-205, both
> > running 4400 software (up to 64 satellites).  One
> is on channel 1, the
> > other channel 11.
> >
> >
> >
> > Then we have a satellite, 4300 software, AP-1000. 
> One dish to Base 1,
> > one dish to Base 2.
> >
> >
> >
> > Satellite links up with Base 1, always has, just
> fine.  But will not
> > stay linked to Base 2.  It was linking for a brief
> period after being
> > rebooted, then dropping, but now doesn't link at
> all.
> >
> > It is not a signal problem - we've changed them to
> 802.11b and mobile
> > router, verified that they link, etc. and all is
> good there.
> >
> >
> >
> > Swapped radios (YDI Sapphire, Lucent Silver,
> Orinoco Silver) - no
> > difference.
> >
> >
> >
> > Any ideas?
> >
> >
> >
> > Regards,
> >
> > Jayson A. Baker
> >
> > Peak Internet Solutions
> >
> > Phone: (719) 686-2540
> >
> > Fax: (719) 686-1864
> >
> >
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> >
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> 
> 
> 
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> 
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> 



        
                
__________________________________
Do you Yahoo!?
Friends.  Fun.  Try the all-new Yahoo! Messenger.
http://messenger.yahoo.com/ 
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

<Prev in Thread] Current Thread [Next in Thread>