Will the 4.45 firmware allow the following to work:
RG1000 with AP+ SEC with 200mw PRISM 2.5 card?
AP1000 with AP+ SEC with 200mw PRISM 2.5 card(s) in one or both slots?
KN200 with AP+ SEC with 200mw PRISM 2.5 card(s) in one or both slots?
Please advise as I'd like to begin upgrades and removal of a few AMPs in our
network if these combinations are supported.
Thanks,
Larry Yunker
Cyber Broadcasting, L.L.C.
----- Original Message -----
From: "Support" <Support@karlnet.com>
To: <karlnet@WISPNotes.com>
Sent: Monday, May 17, 2004 9:23 AM
Subject: [Karlnet] V4.45 Released
> This general release supercedes version 4.44-02. This version includes
> several new features and bug fixes:
>
> A) Hermes II radio support
> B) Hardware/Software ACK selection
> C) Intersil AP
> D) Ethernet manual full-duplex setting fixed (RG+)
> E) AP Radius updated for RFC compliance
> F) WARP redirection fix
> G) Intersil WEP fix
> And more...
>
> For a complete description of the changes in this version please refer
> to the release notes.
>
http://www.karlnet.com/Documents/ReleaseNotes/KarlBridgeKernelReleaseNotes.h
> tm
>
> Thanks
> KarlNet Support
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> ---
> [This E-mail scanned for viruses by Cyber Broadcasting's Declude
AntiVirus]
>
>
---
[This E-mail scanned for viruses by Cyber Broadcasting's Declude AntiVirus]
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|