Use version v4.44 or v4.44-1, I had v4.44-2 on my base station and pings
went through the roof (clients are v4.44-1)
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of Norm Young
> Sent: Sunday, April 18, 2004 1:18 PM
> To: Karlnet Mailing List
> Cc: support@karlnet.com
> Subject: [Karlnet] Ping times to/from a KN-205 basestation
> repeaterKarlBridge/Router v4.44-02-020917 knrgotcn SN-xKNRG+*******458
> V4.35
>
> I've recently added a KN-205/KarlBridge/Router (v4.44-02-020917
knrgotcn
> SN-xKNRG+*********458 V4.35) to our network, using it as a
> repeater/secondary WIPOP to fill in an area that had no coverage.
>
> One of the radios is set up to be a satellite, communicating with the
main
> WIPOP, the other in PtMP/ISP Basestation to service the unserved area.
> The
> satellite is on CH1, the PtMP is on CH7. Signal strength back to the
> main
> WIPOP is very good, that to the one existing (test) client on the
PtMP
> interface is marginal with S/N ratio of 10-12dB.
>
> The whole network is bridged. I've set up a new IP subnet for this
> repeater, with the idea of moving to routing, as I'm going to have
traffic
> for this area that needs to go only to this repeater, but I haven't
> implemented it yet. The whole network is running v4.44, and is a mix
of
> older RGs and a range of KN-50's/Ubicoms using firmware from v1.00-00-
> 052215
> to 1.10-00-101315.
>
> The throughput is good, the ping times and jitter are unacceptably
bad.
> Pings to the repeater from other clients on the same main WIPOP are
about
> normal, 25-100mS range, with most in the 20mS area. Pings to the
repeater
> from the backhaul at the main WIPOP are 11mS-50mS, most being in the
low
> teens.
>
> However, pings through the new repeater to the one client on the PtMP
> (CH7)
> interface are simply awful. From the main WIPOP backbone they are
from
> 14mS-500mS, with most being around 200mS. Pings back from the client
are
> just as bad. Pings from one of the Ethernet interfaces on the
repeater
> back
> to the main WIPOP also are rough, with lots of latency and jitter.
>
> Anyone have any comments on what could be wrong here? I'd say signal
> strength, but I happened to notice these jitter/latency issues with
the
> system while it was burning in on the bench, as well.
>
> Norm
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> --
> [This E-mail scanned for viruses by Declude Virus]
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|