Hi,
We have three KN-100 boards purchased from two different distributors over
the past two weeks.
Neither of which initialize the cards in the slot (tried Lucent Silver,
Orinoco Silver, YDI Sapphire).
When we login w/ the Configurator all it shows is an Ethernet interface.
Looks like it doesn't even see PCMCIA.
Tested all these cards in a KN-200 we have, they all work fine - not the
cards.
Changed the jumper from 3.3V to 5V - that's not the problem.
Done a reload on all boards numerous times - again, not the problem.
Anyone else having these problems? Bad batch of KN-100 boards. again?
Don't they run ANY of these through ANY sort of QC? I can't count the
number of boards we've received DOA.
Anyone's input is greatly appreciated as KN is out until Monday I'm sure
(and we need a board for Monday morning!)
Regards,
Jayson A. Baker
Peak Internet Solutions
Phone: (719) 686-1490
Facsimile: (719) 686-1864
E-Mail: jbaker@peakinet.net
Web: http://www.peakinet.net/
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|