Hi,
> Supposedly they work in TC mode, just not 802.11 mode.
>
> Why? Same thing on an older WavePoint II w/ Karlnet firmware.
Because there is still no tertiary fimware for PRISM cards included in
karlbridge kernel (only for Hermes based cards).
Kevin told us (several months ago), that support for Prism cards in AP mode is
SCHEDULED for version 4.45
http://lists.wispnotes.com/pipermail/karlnet/2003-November/003601.html
Regards
Peter
>
> Regards,
> Jayson A. Baker
> Peak Internet Solutions
>
>
>
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com [mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of Jayson A. Baker
> Sent: Wednesday, March 31, 2004 10:13 AM
> To: karlnet@WISPNotes.com
> Subject: [Karlnet] Senao cards
>
> Do the 200mW Senao cards no longer work in the KN-100 boards?
>
> All I get is a blinking light, and the board stops booting (cannot access
> config, etc.).
>
> Running SG4001 software.
>
>
>
> Regards,
>
> Jayson A. Baker
>
> Peak Internet Solutions
>
> Phone: (719) 686-2540
>
> Fax: (719) 686-1864
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|